simple.json 1.59 KB
Newer Older
Tomek Mrugalski's avatar
Tomek Mrugalski committed
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45
# This is an example configuration file for DHCPv6 server in Kea.
# It's a basic scenario with four IPv6 subnets configured. It is
# assumed that one subnet (2001:db8:1::/64 is available directly
# over eth0 interface.

{ "Dhcp6":

{ 
# Kea is told to listen on eth0 interface only.
  "interfaces": [ "eth0" ],

# We need to specify lease type. As of May 2014, three backends are supported:
# memfile, mysql and pgsql. We'll just use memfile, because it doesn't require
# any prior set up.
  "lease-database": {
    "type": "memfile"
  },

# Addresses will be assigned with preferred and valid lifetimes
# being 3000 and 4000, respectively. Client is told to start
# renewing after 1000 seconds. If the server does not repond
# after 2000 seconds since the lease was granted, client is supposed
# to start REBIND procedure (emergency renewal that allows switching
# to a different server).
  "preferred-lifetime": 3000,
  "valid-lifetime": 4000,
  "renew-timer": 1000,
  "rebind-timer": 2000,

# The following list defines subnets. Each subnet consists of at
# least subnet and pool entries.
  "subnet6": [ 
    {
      "pool": [ "2001:db8:1::/80" ],
      "subnet": "2001:db8:1::/64",
      "interface": "eth0"
    }
  ]
},

# The following configures logging. Kea will log all debug messages
# to /var/log/kea-debug.log file.
"Logging": {
    "loggers": [
        {
Tomek Mrugalski's avatar
Tomek Mrugalski committed
46
            "name": "kea-dhcp6",
Tomek Mrugalski's avatar
Tomek Mrugalski committed
47 48 49 50 51 52 53 54 55 56 57 58 59
            "output_options": [
                {
                    "output": "/var/log/kea-debug.log"
                }
            ], 
            "debuglevel": 99,
            "severity": "DEBUG"
        }
    ]
}

}