Commit 8b9fc761 authored by Mark Andrews's avatar Mark Andrews

minor changes from Jeremy [RT #16863]

parent d71e2e0c
......@@ -18,7 +18,7 @@
- PERFORMANCE OF THIS SOFTWARE.
-->
<!-- $Id: named-checkzone.docbook,v 1.30 2007/05/09 01:32:08 marka Exp $ -->
<!-- $Id: named-checkzone.docbook,v 1.31 2007/05/09 06:18:44 marka Exp $ -->
<refentry id="man.named-checkzone">
<refentryinfo>
<date>June 13, 2000</date>
......@@ -117,7 +117,7 @@
Additionally, it applies stricter check levels by default,
since the dump output will be used as an actual zone file
loaded by <command>named</command>.
When manaully specified otherwise, the check levels must at
When manually specified otherwise, the check levels must at
least be as strict as those specified in the
<command>named</command> configuration file.
</para>
......
......@@ -18,7 +18,7 @@
- PERFORMANCE OF THIS SOFTWARE.
-->
<!-- $Id: dig.docbook,v 1.35 2007/05/09 01:32:08 marka Exp $ -->
<!-- $Id: dig.docbook,v 1.36 2007/05/09 06:18:44 marka Exp $ -->
<refentry id="man.dig">
<refentryinfo>
......@@ -251,7 +251,7 @@
The <option>-t</option> option sets the query type to
<parameter>type</parameter>. It can be any valid query type
which is
supported in BIND 9. The default query type "A", unless the
supported in BIND 9. The default query type is "A", unless the
<option>-x</option> option is supplied to indicate a reverse lookup.
A zone transfer can be requested by specifying a type of AXFR. When
an incremental zone transfer (IXFR) is required,
......
......@@ -18,7 +18,7 @@
- PERFORMANCE OF THIS SOFTWARE.
-->
<!-- $Id: rndc.conf.docbook,v 1.15 2007/05/09 01:32:09 marka Exp $ -->
<!-- $Id: rndc.conf.docbook,v 1.16 2007/05/09 06:18:45 marka Exp $ -->
<refentry id="man.rndc.conf">
<refentryinfo>
<date>June 30, 2000</date>
......@@ -111,7 +111,7 @@
name of a key statement in the file. The port number
specifies the port to connect to. If an <option>addresses</option>
clause is supplied these addresses will be used instead of
the server name. Each address can take a optional port.
the server name. Each address can take an optional port.
If an <option>source-address</option> or <option>source-address-v6</option>
of supplied then these will be used to specify the IPv4 and IPv6
source addresses respectively.
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment