single-subnet.json 1.08 KB
Newer Older
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
# This is an example configuration file for DHCPv4 server in Kea.
# It's a basic scenario with four IPv6 subnets configured. In each
# subnet, there's a smaller pool of dynamic addresses.

{ "Dhcp4":

{ 
# Kea is told to listen on eth0 interface only.
  "interfaces": [ "eth0" ],

# We need to specify lease type. As of May 2014, three backends are supported:
# memfile, mysql and pgsql. We'll just use memfile, because it doesn't require
# any prior set up.
  "lease-database": {
    "type": "memfile"
  },

# Addresses will be assigned with preferred and valid lifetimes
# being 3000 and 4000, respectively. Client is told to start
# renewing after 1000 seconds. If the server does not repond
# after 2000 seconds since the lease was granted, client is supposed
# to start REBIND procedure (emergency renewal that allows switching
# to a different server).
  "valid-lifetime": 4000,
  "renew-timer": 1000,
  "rebind-timer": 2000,

# The following list defines subnets. We have only one subnet
# here.
  "subnet4": [ 
  {    "pool": [ "192.0.2.1 - 192.0.2.200" ],
       "subnet": "192.0.2.0/24"  } ]
}

}