Commit fc10ca80 authored by Marcin Siodelski's avatar Marcin Siodelski
Browse files

[5478] Default configuration values documented.

parent f22e93f0
......@@ -3219,7 +3219,8 @@ both the command and the response.
a duration in seconds between the last heartbeat (or other command sent
to the partner) and sending the next heartbeat. The heartbeats are sent
periodically to gather the status of the partner and to verify whether
the partner is still operating.</para></listitem>
the partner is still operating. The default value of this parameter is
10.</para></listitem>
<listitem><para><command>max-response-delay</command> - specifies a
duration in seconds since the last successful communication with the
......@@ -3231,6 +3232,7 @@ both the command and the response.
may transition to the <command>partner-down</command> state (when
<command>max-unacked-clients</command> is 0) or trigger failure
detection procedure using the values of the two parameters below.
The default value of this parameter is 60.
</para></listitem>
<listitem><para><command>max-ack-delay</command> - is one of
......@@ -3241,7 +3243,8 @@ both the command and the response.
trying to communicate with the DHCP server. This parameter specifies the
maximum time for the client to try to communicate with the DHCP server,
after which this server assumes that the client failed to communicate
with the DHCP server (is "unacked").</para></listitem>
with the DHCP server (is "unacked"). The default value of this parameter
is 10.</para></listitem>
<listitem><para><command>max-unacked-clients</command> - specifies
how many "unacked" clients are allowed (see <command>max-ack-delay</command>)
......@@ -3251,7 +3254,8 @@ both the command and the response.
mechanism. In this case, the server which can't communicate with the
partner over the control channel assumes that the partner server is
down and transitions to the <command>partner-down</command> state
immediately.</para></listitem>
immediately. The default value of this parameter is 10.</para>
</listitem>
</itemizedlist>
</para>
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment