Commit 0c19bb1c authored by Thomas Markwalder's avatar Thomas Markwalder

[5683] Minor word-smithing

parent ded5f663
......@@ -133,12 +133,12 @@
sometimes it may be convenient to create the lease
administratively. The <command>lease4-add</command> command requires
at least two parameters: an IPv4 address, and an identifier: hardware
(MAC) address. A third parameter, subnet-id, used to be mandatory in
Kea 1.4.0, but since 1.5.0 it is optional. If not specified or
specified value is 0, Kea will try to figure its value out on its own
by running a subnet selection procedure. If specified, however, its
value much match existing subnet. The simplest successful call might
look as follows:
(MAC) address. A third parameter, subnet-id, was mandatory in
Kea 1.4.0, but is optional beginning with Kea 1.5.0.. If not
specified or specified value is 0, Kea will try to determine the
value by running a subnet selection procedure. If specified, however,
its value must match the existing subnet. The simplest successful
call might look as follows:
<screen>
{
"command": "lease4-add",
......@@ -154,9 +154,9 @@
IPv6 address, and IAID value (identity association identifier, a value
sent by clients) and a DUID. The same principle for subnet-id as in
lease4-add applies. If not specified or specified value is 0, Kea will
try to figure its value out on its own by running a subnet selection
procedure. If specified, however, its value much match existing
subnet. For example:
try to determine the value own by running a subnet selection procedure.
If specified, however, its value must match the existing subnet. For
example:
<screen>
{
"command": "lease6-add",
......@@ -670,9 +670,9 @@ An example IPv4 lease deletion by "hw-address" looks as follows:
<para>Subnet-id parameter, used to be mandatory in Kea 1.4.0, but it
is optional since 1.5.0. If not specified or specified value is 0, Kea
will try to figure its value out on its own by running a subnet
selection procedure. If specified, however, its value much match
existing subnet.</para>
will try to determine its value by running a subnet selection
procedure. If specified, however, its value must match the existing
subnet.</para>
<para>The optional boolean parameter "force-create" specifies
if the lease should be created if it doesn't exist in the database.
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment